Mailing List CGatePro@mail.stalker.com Message #105912
From: Palvelin Postmaster <postmaster@palvelin.fi>
Subject: Re: Routing all but one address
Date: Fri, 27 Nov 2015 17:15:39 +0200
To: CommuniGate Pro Discussions <CGatePro@mail.stalker.com>
X-Mailer: Apple Mail (2.3096.5)
Humm…this doesn’t seem to work

R.M:<thisone@domain.dom> = thisone@domain.dom.here
R:M:<*@domain.dom> = thisbox@domain.dom.here

thisone@domain.dom goes to loop with the above rules. All other addresses get routed to thisbox@domain.dom properly.



> On 27.11.2015, at 16:58, Nicolas Hatier <nicolas.hatier@niversoft.com> wrote:
>
>
> Router rules are applied in order, so yes, just put your exception BEFORE the global rule, and make good use of the .here specifier if needed.
>
> I guess that would look like this (not tested):
>
> R:M:<thisone@domain.dom> = thisone@domain.dom.here
> R:M:<any-address@domain.dom> = thisbox@domain.dom.here
>
> Nicolas
>
>
> On 2015-11-27 09:53, Palvelin Postmaster wrote:
>> Is it possibe to use the Router to route all incoming email of a specific domain to a specific mailbox EXCEPT one email address? For example
>>
>> any-address@domain.dom is routed to thisbox@domain.dom
>> except
>> thisone@domain.dom is routed to thisone@domain.dom
>>
>
>
> #############################################################
> This message is sent to you because you are subscribed to
> the mailing list <CGatePro@mail.stalker.com>.
> To unsubscribe, E-mail to: <CGatePro-off@mail.stalker.com>
> To switch to the DIGEST mode, E-mail to <CGatePro-digest@mail.stalker.com>
> To switch to the INDEX mode, E-mail to <CGatePro-index@mail.stalker.com>
> Send administrative queries to  <CGatePro-request@mail.stalker.com>

Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster